ICP DAS USA’s ECAT-2511-A EtherCAT to single-mode fiber optic converter.
The ECAT-2511-A is designed to convert EtherCAT signals to optical signals on a fiber optic cable and to reshape the EtherCAT signal to compensate for distortion, as well as isolate the bus error due to the wire short or disturbance. With the advantage of fiber optic, the ECAT-2511-A secure data transmission via fiber optic transmission, and helps the EtherCAT network to prevent the noise from EMS/RFI interference.
50% Cost Saving for Fiber Optic Infrastructures: With a pair of ECAT-2511 series products (ECAT-2511-A and ECAT-2511-B), you can double the utilization of your existing, costly fiber optic cable, and save 50% of the cost of a newly installed fiber optic application.
- Powerful MCU handles efficient network traffic
- Distance between Stations up to 15 km (100BASE-FX)
- 50% Cost Saving for Fiber Optic Infrastructures
- EtherCAT conformance test tool verified
- ESD Protection 4 KV Contact for each port
RJ-45 x 1 Distance between Stations: Max. 100 m (100BASE-TX) Data Transfer Medium: Ethernet/EtherCAT Cable (Min. CAT 5e)
Single-Mode; SC connector x 1
TX: 1310, RX: 1550 nm
Distance between Stations
25 km (9/125 ?m recommended)
Redundant Input Range
+12 ~ +48 VDC
0.1 A @ 24 VDC
Power reverse polarity protection
3-Pin Removable Terminal Block (5.08mm)
110mm x 90mm x 33mm (H x W x D)
-25°C ~ + 75°C
-30°C ~ + 80°C
Ambient Relative Humidity
10 ~ 90% RH, non-condensing